How To Use Video
Watch our easy to follow instructional video on how to use the GloWhiter Teeth Whitening System in four easy steps.
Get Your Teeth Whitening Kit Today!
Step By Step Guide
GloWhiter’s four easy steps to a whiter smile
Step 1 – Mould
Boil enough water to submerge the mouth guard not including the tab and remove from heat for 6-7 minutes. Holding the tab submerge one of the mouth guards into the hot water for 10-15 seconds until guard appears to soften (DO NOT OVERHEAT MOUTH GUARDS). Place the mouth guard into your mouth covering your upper teeth. Close your mouth and suck all air and excess water from mouth guard creating suction between mouth guard and teeth. Gently push the guard into your teeth by pushing on your upper lip with your fingers. Wait 10-15 seconds before removing the mouth guard from your mouth. Place the mouth guard into a cup of cold water for 10 seconds to complete curing process. Repeat for the lower mouth guard.
Step 2 – Trim
After moulding both mouth guards, use scissors to cut any excess from the tops of the guards at the gum-line. Trimming the mouth guards at the gum-line will avoid any possible soft tissue irritation caused by whitening.
Step 3 – Apply
Place a small drop of gel on each tooth impression on the upper and lower mouth guards. Place the upper and lower mouth guards into your mouth and rest properly into the teeth impressions. Put gentle pressure on the upper mouth guard by pushing on your upper lip with your fingers in order to insure a tight fit. Do the same on the lower mouth guard.
Step 4 – Whiten
Remove the plastic disc from battery section of the LED light, turn the light on by pressing the white button, then place the light in your mouth. Wear the mouth guards for approximately 20-30 minutes total time. We recommend starting at 20 minutes and gradually increasing the amount of time worn. Remove mouth guards and rinse in lukewarm water. Store in the guard case provided in your kit. Repeat daily until ideal shade of white is achieved.